LP10TRADE SERVICES

LP10 DAMP & VENTILATION

Diagnose the moisture before covering the stain.

Similar-looking patches can come from condensation, leaks, rain penetration, ground moisture or thermal bridging. LP10 asks for diagnosis and evidence before treatment so cleaning or decoration is not presented as a cure.

Ask about damp or ventilation

SERVICE TYPES

Choose the type of work.

01Damp & Moisture SurveyInvestigation of moisture patterns, property construction, occupancy, ventilation and likely sources before remedial work is proposed.→02Condensation DiagnosisAssessment of surface condensation, humidity, heating, airflow and cold surfaces rather than assuming rising damp.→03Mould Cause InvestigationIdentifying likely moisture and ventilation causes before cleaning, coating or repair options are considered.→04Mould RemediationDefined cleaning and treatment of suitable affected surfaces alongside a plan to control the underlying moisture source.→05Penetrating Damp InvestigationInvestigation of rain entry through roofs, walls, openings, gutters or external defects with the repair trade identified.→06Rising Damp AssessmentEvidence-led assessment of possible ground moisture, bridging and alternative causes before a damp-proofing proposal.→07Post-Leak Drying AssessmentMoisture checks and recovery planning after the plumbing, roof or drainage leak has been repaired.→08Bathroom Ventilation AssessmentReview of fan performance, duct route, air replacement, controls and moisture behaviour in a domestic bathroom.→09Kitchen Extract Ventilation AssessmentAssessment of suitable kitchen extraction routes and airflow; electrical and core-drilling work are scoped separately.→10Extractor Fan Replacement CoordinationSpecification and coordination of a suitable replacement fan, controls and duct arrangement with electrical work assigned appropriately.→11Positive Input VentilationPIV assessment and installation enquiries where the property, loft, airflow path and condensation pattern are suitable.→12Mechanical Extract VentilationContinuous or demand-controlled extract-system enquiries following a property ventilation assessment.→13MVHR Assessment & ServicingDomestic heat-recovery ventilation design, fault, filter, balancing and servicing enquiries for suitable systems.→14Trickle Vent & Background VentilationAssessment and installation enquiries for suitable background ventilation without claiming vents alone solve every damp issue.→15Air Brick & Subfloor VentilationChecking and improving suitable suspended-floor airflow after levels, blockages and moisture sources are assessed.→16Thermal Bridging & Cold-Surface AssessmentInvestigation of recurring cold areas and surface mould with insulation and construction details considered.→17Basement & Cellar Damp AssessmentDiagnosis and remedial-design enquiries for below-ground moisture, drainage and ventilation conditions.→18Damp-Damaged Finish ReinstatementPlaster, board and decorative reinstatement only after the source is controlled and the structure is suitably dry.→

KEEP PLANNING

Related guides.

Browse every guide →

CURRENTLY LISTED PROVIDERS

Damp, Mould & Ventilation Services.

These profiles are selected from their published services. Open a profile to check its work, coverage and direct contact options.

We don’t have a damp and ventilation specialist listed yet.

The service guides are available now. Provider names and coverage will appear only after a real business has been checked and published.

Join LP10Recommend a damp and ventilation specialist →

KEEP EXPLORING

Service, area and provider routes.

HOW TO START

Show the pattern, not only the worst patch.

Send the postcode, property age and type, photographs of the room and exterior, when marks appear, humidity readings if available, heating and ventilation habits, known leaks and previous treatments. Do not disturb suspect asbestos-containing finishes.

Send an enquiryBrowse available providers →